__ __ __ __ _____ _ _ _____ _ _ _
| \/ | \ \ / / | __ \ (_) | | / ____| | | | |
| \ / |_ __\ V / | |__) | __ ___ ____ _| |_ ___ | (___ | |__ ___| | |
| |\/| | '__|> < | ___/ '__| \ \ / / _` | __/ _ \ \___ \| '_ \ / _ \ | |
| | | | |_ / . \ | | | | | |\ V / (_| | || __/ ____) | | | | __/ | |
|_| |_|_(_)_/ \_\ |_| |_| |_| \_/ \__,_|\__\___| |_____/|_| |_|\___V 2.1
if you need WebShell for Seo everyday contact me on Telegram
Telegram Address : @jackleet
For_More_Tools:
How to recover your system:
---------------------------
You need to manually set up what is needed in your case
to boot the kernel (by default named kernel-HOSTNAME)
plus initramfs/initrd (by default named initramfs-HOSTNAME.img)
that contains the Relax-and-Recover rescue/recovery system
on your replacement hardware.
For example to directly boot the ReaR recovery system from within
a Linux system that is already running on your replacement hardware
you may use 'kexec':
1. Copy the kernel and the ReaR recovery system initramfs
on your already running Linux system.
2. Load the kernel and ReaR's initramfs and provide an appropriate
kernel command line to run the ReaR recovery system in a ramdisk
and use standard VGA 80x25 text mode (one single command line):
kexec -l kernel-HOSTNAME
--initrd=initramfs-HOSTNAME.img
--command-line='root=/dev/ram0 vga=normal'
You may have to add hardware dependent kernel command line
parameters if needed for your replacement hardware,
cf. /proc/cmdline of your system.
3. Boot the loaded kernel (plus ReaR's initrd):
kexec -e
That will instantly reboot into the loaded kernel without
a clean shutdown of the currently running Linux system.
4. In the booted ReaR recovery system log in as 'root'
(this may only work directly on the system console)
and recover your system:
rear recover
That will completely replace the Linux system from before
so it does not matter when it was not cleanly shut down.