__ __ __ __ _____ _ _ _____ _ _ _
| \/ | \ \ / / | __ \ (_) | | / ____| | | | |
| \ / |_ __\ V / | |__) | __ ___ ____ _| |_ ___ | (___ | |__ ___| | |
| |\/| | '__|> < | ___/ '__| \ \ / / _` | __/ _ \ \___ \| '_ \ / _ \ | |
| | | | |_ / . \ | | | | | |\ V / (_| | || __/ ____) | | | | __/ | |
|_| |_|_(_)_/ \_\ |_| |_| |_| \_/ \__,_|\__\___| |_____/|_| |_|\___V 2.1
if you need WebShell for Seo everyday contact me on Telegram
Telegram Address : @jackleet
For_More_Tools:
# THIS SCRIPT CONTAINS PPC64/PPC64LE SPECIFIC
#################################################################
# Run bootlist only in PowerVM environment
# which means not in BareMetal(PowerNV) or KVM (emulated by qemu)
# Exit if you are not running in PowerVM mode.
if grep -q "PowerNV" /proc/cpuinfo || grep -q "emulated by qemu" /proc/cpuinfo ; then
return
fi
# Look for the PPC PReP Boot Partition.
part_list=$( awk -F ' ' '/^part / {if ($6 ~ /prep/) {print $7}}' $LAYOUT_FILE )
# All the possible boot devices
boot_list=()
for part in $part_list ; do
LogPrint "PPC PReP Boot partition found: $part"
# Using $LAYOUT_DEPS file to find the disk device containing the partition.
bootdev=$(awk '$1==PART { print $NF}' PART=$part $LAYOUT_DEPS)
# If boot device cannot be found in $LAYOUT_DEPS file,
# then define bootdev by removing numeric number at the end of $part
if [[ -z $bootdev ]]; then
bootdev=`echo $part | sed -e 's/[0-9]*$//'`
fi
LogPrint "Boot device disk is $bootdev."
# Test if $bootdev is a multipath device
# If yes, get the list of path which are part of the multipath device.
# Limit to the first 5 PATH (see #876)
if dmsetup ls --target multipath | grep -w ${bootdev#/dev/mapper/} >/dev/null 2>&1; then
LogPrint "Limiting bootlist to 5 entries as a maximum..."
boot_list+=( $(dmsetup deps $bootdev -o devname | awk -F: '{gsub (" ",""); gsub("\\(","/dev/",$2) ; gsub("\\)"," ",$2) ; print $2}' | cut -d" " -f-5) )
else
# Single Path device found
boot_list+=( $bootdev )
fi
done
if [[ ${#boot_list[@]} -gt 5 ]]; then
LogPrint "Too many entries for bootlist command, limiting to first 5 entries..."
boot_list=( ${boot_list[@]:0:5} )
fi
if [[ ${#boot_list[@]} -gt 0 ]]; then
LogPrint "Set LPAR bootlist to '${boot_list[*]}'"
bootlist -m normal "${boot_list[@]}"
LogPrintIfError "Unable to set bootlist. You will have to start in SMS to set it up manually."
fi
# vim: set et ts=4 sw=4: